Topic | Overview and single-meter view don't match readings

This topic has 3 replies, 2 voices, and was last updated 7 years, 7 months ago by admin.

Viewing 3 reply threads

Author
Posts
- November 8, 2015 at 11:43 am #5644 Reply
  John
  Guest
  I’ve clipped a 10K resistor to the common and ohms leads, and I see 10.5230 ohm (should be kohm) in the overview/scan view, but I see 10.5069 kohms in the single-meter view. Shouldn’t these two values match?
- November 8, 2015 at 11:29 pm #5657 Reply
  admin
  Keymaster
  They should be. It looks like the unit prefix is not being displayed on the overview page. Thanks for finding this, I added a git issue.
- November 10, 2015 at 4:35 am #5677 Reply
  Anonymous
  Guest
  It’s not just the units. The values are a few tenths of a percent different. The small offset was repeatable on my unit.
- November 10, 2015 at 10:13 am #5685 Reply
  admin
  Keymaster
  Oh interesting – thank you. I have an idea what the issue could be but haven’t had a chance to check the code yet, will let you know when I do.
Author
Posts

Viewing 3 reply threads