Home › Forums › Mooshimeter Support › Scope and settings
- This topic has 0 replies, 1 voice, and was last updated 8 years, 2 months ago by
Jean Des Rosiers.
Viewing 0 reply threads
- AuthorPosts
Jean Des Rosiers
GuestIt would be nice if the settings chosen in meter mode were carried over to the scope screen. For example: setting the meter to DC to measure a voltage on which an AC component is present. In meter mode, the voltage is displayed correctly, showing variations in accordance with the sampling but in graph mode, only the AC component of the waveshape is displayed. This would be OK if AC was chosen in meter mode, just as it is done on an oscilloscope. If DC is selected on the meter, then the graph shoud show the zero reference with the waveshape towards the top of the screen (or bottom depending on polarity). I don’t know what is involved with this demand, but it would sure be nice.
- AuthorPosts
Viewing 0 reply threads